Q: Hi! What is the size of the large lip strike plate, the size of the lip as it bends until the outer side of it.
A: I do not have an Ultra Hardware 58151 large lip strike plate here to measure, but I can tell you this is a very generic strike, and measuring another generic strike, the height of the lip of the strike is 3-3/8" and the the length of the lip, from where the curve starts, the the end of the lip is 7/16"
Is there a follow up question that we can perhaps attempt to answer? We take deep pride in our technical expertise, as we know it separates us from our competition, so don't hesitate to ask.
Please reply to this email or contact our sales department here:
Click Here
if we can assist you by answering further questions or with entering this order and please let us know if there is anything else we can help with. If this answer was helpful - please consider following us on Twitter
Click Here
or liking our page on Facebook
Click Here
Q: Hi again! Thank you for your answer. You mentioned that the size of the lip from where the curve starts is 7/16 inches. Could you also tell me the size of the distance between the screw hole until the beginning of the lip, as shown by red line on the image attached. I just want to be sure that it will fit the space. Thank you very much.
A: Regarding the TA DL-TA001-US32D ASA Strike 4-7/8" - Satin Stainless Steel Finish as seen here:
Click Here
From the vertical centerline of the screw hole to where the lips and begins to occur is at 13/16"
The video is seen here:
Click Here
Details all of the dimensional properties of the exact strike linked to above.
Is there a follow up question that we can perhaps attempt to answer? We take deep pride in our technical expertise, as we know it separates us from our competition, so don't hesitate to ask.
Please reply to this email or contact our sales department here:
Click Here
if we can assist you by answering further questions or with entering this order and please let us know if there is anything else we can help with. If this answer was helpful - please consider following us on Twitter
Click Here
or liking our page on Facebook
Click Here