Q: can you just use the code or do you have to use # or* at the end
A: When simply entering the code to operate the unit no special characters are required at the end.
Is there a follow up question that we can perhaps attempt to answer? We take pride deep in our technical expertise, as we know it separates us from our competition, so don't hesitate to ask.
Please reply to this email or contact our sales department here:
Click Here
if we can assist you by answering further questions or with entering this order and please let us know if there is anything else we can help with.
Q: Can this particular keypad can be used with battery backup?
A: Yes indeed you can power this IEI 212SE Sealed Environmental Keypad will a power supply that incorporates a battery backup option.
Q: so i pressed the lil black button to rest set for a new master code but its not working...PLEASE HELP!!!
A: The programming options chart can be seen on page three of the installation instructions as seen here:
Download File
Q: My keypad wont go into programming mode
A: We understand that you have attempted multiple times to set the keypad into programming mode and have even contacted the manufacturer for assistance and they've declined to provide that to you. And as a result our only suggestion would be to perform an outright for replacement of the keypad.
Q: where is sw1 located
A: The SWI Programming Switch can be seen in the manufacturers wiring diagram as seen here:
Download File
Q: how to reset to factory master code?
A: Please proceed through all of the programming steps as shown in the programming instructions as seen here:
Download File
Q: Need to change the code that used by everyone to go in and out of a secured area. This is a IEI 0-232140. Can’t seem to find the correct codes to put in to program
A: Are you in possession of the code that currently operates the keypad as you will need this in order to program the unit?
Q: Yes I am I have the current code
A: What step of the programming instructions has seen here are you having trouble with:
Download File
Q: I have a IEI with a Green,yellow and Red light display the door locks after 5 seconds and the green light stays on and will not allow code to reopen until after 15 seconds how can I shorten the green light to 5 seconds.
A: I do believe the answer you are looking for can be seen in the programming options chart on page three of the manufacturers programming instructions as seen here:
Download File
Q: keypad iei 212se accepts code but does not release the door. The single red light changes to green but does not unlock.
A: Is there power going to the lock the keypad is the switch for?
Q: How do I buy and install a battery backup for the 212SE keypad?
A: Great question. Is your power supply providing power to the IEI 212SE Sealed Environmental Keypad?
Q: Is there a clear plastic case that can be used with this keypad for exterior use?
A: Are you looking for a case that is hinged at the very top?