B-700 115V

Wall Preparation: Secure mounting base on wall using template provided. For masonry walls, provide four 1/4'' (6mm)
expansion shields or anchors and secure with #14 sheet-metal screws (not furnished). For plaster or dry wall construction,
provide concealed backing to comply with local building codes and secure with #14 x 2-3/4'' (6.3 x 70mm) or longer roundhead
sheet-metal screws or 1/4'' (6mm) toggle bolts (not furnished). Provide electrical service from nearest distribution
panel to dryer mounting base in conformance with local electrical codes.
Wiring Instructions:
1. For 115-Volt Dryers — Connect ground wire to ground terminal marked , the black or hot wire to terminal marked L1,
and neutral or white wire to terminal marked N. A DEDICATED LINE IS REQUIRED FOR EACH 115-VOLT
INSTALLATION.
2. For 208–240-Volt Dryers — Connect ground wire to ground terminal marked and the 208- or 240-volt wires to
terminals marked L1 and L2.
Notes: Electronic sensor in AutoPilot dryers will pick up movement within 7-1/2'' (190mm) of air-outlet nozzle. Use caution
when choosing location for AutoPilot dryers in confined areas. Consider proximity to doorways and other traffic areas.
Bobrick automatic hand dryers should be installed 15" (380mm) above any projection or horizontal surface which may
interfere with the operation of the automatic sensor

Cover — One-piece, minimum 1/8'' (3mm) thick, grey iron-casting is finished in high-gloss, acid-resistant, multicoat vitreous
enamel. Equipped with a two-position, self-returning, chrome-plated air-outlet nozzle. Graphic operating instructions are
permanently fused with vitreous enamel cover for maximum vandal- and wear-resistance. Air-inlet and -outlet openings are
equipped with vandal-resistant grilles. Cover is secured to mounting base with two concealed, vandal-resistant, recessed hexscrews.
Mounting Base — 14-gauge (2mm) plated steel with four 19/64'' (7.5mm) diameter mounting holes.
Motor — Universal, 1/10 hp, 6200 rpm, on resilient mounting. Sealed ball bearing at drive-shaft end and self-lubricating
sleeve bearing at nondrive end. Equipped with automatic thermal-overload switch.
Fan — Dynamically balanced, single-inlet centrifugal fan is mounted on motor shaft; directs airflow through heating element
at 150 cfm.
Heating Element — Coiled nickel-chrome heating element is mounted in mica frame and protected by an automatic
thermal-overload switch. Heating element, which is located on inlet side of fan, heats air without hot spots — inaccessible to
vandals.
Electronic Control — Infrared sensor automatically turns dryer on when hands or self-returning nozzle are held under airoutlet
opening and across path of sensor. Remove hands or release self-returning nozzle from path of sensor and dryer stops.
Electronic sensor has automatic shutoff approximately 1-1/2 minutes after dryer turns on if inanimate object is placed across
air-outlet opening. After inanimate object is removed, electronic sensor automatically resets itself and dryer operates normally