Bobrick B-5806x18 Straight Grab Bar

Bobrick B-5806x18 Concealed Mounting

Item #	Description
B-5806x18	Bobrick B-5806x18 Series Concealed Mounting with Snap Flange Grab Bars

Specifications:

Satin-finish 18-gauge type 304 stainless steel tubing 1-1/4" (32mm) diameters

Bar passes through flange and is heliarc welded to form single structural unit.

Cover snaps over mounting flange to conceal screws.

Concealed mounting flange 1/8" (3mm) thick stainless steel plate, 2" W x 3-1/8" H (50 x 80mm), with two screw holes for concealed anchors

Cover is 22-gauge (0.8mm) stainless steel with satin-finish, 3-1/4" (85mm) dia

Grab bars that provide 1-1/2" (38mm) clearance from the wall can support loads in excess of 900 pounds (408-kg) when properly installed

Meets ADA Accessibility Guidelines in U.S.A

All joints and supports are contour cut and welded.

Concealed anchors and fasteners available as an optional accessory

Peened nonslip gripping surface available.

Questions?

sales@absupply.net

"Bobrick copyrighted product images are used with the permission of Bobrick Washroom Equipment, Inc."

Installation Instructions:

Provide concealed anchor device or backing as specified or required in accordance with local building codes before wall is finished. Fasten concealed mounting flanges to anchor device or backing with two screws in each flange. Snap flange covers over each mounting flange to conceal mounting screws. Concealed anchor devices and mounting screws are not included with Bobrick grab bars and must be specified as an accessory. For Grab Bars with an Intermediate Flange(s), Pull Snap-Flange Covers away from mounting flanges. Place grab bar in desired mounting location. Use intermediate flange as a template to mark location of mounting screws at intermediate flange only. Mark screw locations at the center of the slot in the middle of the double-keyhole shaped mounting holes (2) in the intermediate flange. Remove grab bar from wall. Drive the intermediate flange mounting screws into wall at marked locations. Note: Make sure to leave a space of just over 1/8'' (3.17mm) between the underside of the screw head and the wall. install grab bar on the wall by placing the round ends of the intermediate flange double-keyhole shaped mounting holes over the mounting screws are located in the middle of the flange slots. Install the mounting screws into the wall at the end flanges and secure tightly. Tighten the mounting screws at the intermediate flange. Press all snap-flange covers into place to conceal mounting flanges.

Materials:

Grab Bar — 18-8 S, type-304, 18-gauge (1.2mm) stainless steel tubing with satin finish. 1-1/4" (32mm) outside diameter. Ends are heliarc welded to
concealed mounting flanges. Clearance between the grab bar and wall is 1-1/2" (38mm).
Concealed Mounting Flanges — 18-8 S, type-304, 1/8" (3mm) thick, stainless steel plate; end flanges 2" x 3-1/8" (50 x 80mm) with two holes for
attachment to wall. Intermediate flanges 2-5/8" x 3-1/8" (65 x 80mm) wide x 3-1/8" (80mm) diameter.
Snap Flange Covers — 18-8 S, type-304, 22-gauge (0.8mm) drawn stainless steel with satin finish. 3-1/4" (85mm) diameter x 5/8" (16mm) deep. Each
cover snaps over mounting flange to conceal mounting screws.

B-5806x18

Bobrick B-5806x18 Straight Grab Bar - 18 inch